Tag Archives: installation

Nut Grade Mark Visibility

Does it matter if we install nuts on A325s and A490s with the manufacturer’s ID and grade mark showing, or can they be installed either way?

There is no published requirement for making sure the ID marks are on the outside and visible. The main concern would be being able to ascertain that the proper nuts were installed. If all the ID markings are on the inside, they would not be visible, and an inspector could not see them. That said,... Read more

Anchor Bolts Too Low or High

What do I do if I poured my anchor bolts too low or too high?

The answer can be found in AISC Design Guide 1,Section 2.11.3: “Anchor rod projections that are too short or too long must be investigated to determine if the correct anchor rods were installed. If the anchor rod is too short, the anchor rod may be projecting below the foundation. If the rod projection is too long,... Read more