What is the difference between A194 grade 7 and grade 7L nuts?

A194 grade 7 nuts are commonly used nuts for both high temperature and low temperature applications, and is commonly paired with bolts made to either A193 or A320. When used in conjunction with A320 bolts in a low temperature application, or if specially requested, they are charpy tested to assure they will perform well in a low temperature environment. When that charpy test passes, the nuts are marked with an “L” to show that they have been tested. The same is true with A194 grade 4 and 4L nuts, although Grade 4 and 4L nuts are being withdrawn from the A194 standard by the ASTM committee due to lack of use and material availability.

Written ,

10 comments

    @ thanks Dane, However understand the Gr 7L is not listed in the ASTM A194 standard.
    Other hand Gr 7 is done with impact testing by default as per standard A703.

    Best regards
    Anjani

    Are these bolts suitable to be used with stainless steel flanges? i.e. not cause galvanic corrosion?

    @Sean- The largest variable in galvanic corrosion is the atmosphere. Metals will react differently in the presence of different catalysts i.e water, salt water, acids, etc. A metallurgist would need to be consulted in order to derive a complete answer for your question.

    @Cade- The difference is chemistry. Mechanically they are identical, but the 4L is made from slightly different steel than the 7L.

    @Andi- Normally, grade 7L nuts would be an acceptable alternative for grade 4. The ASTM committee has actually removed grade 4 from A194, so grade 7 will be the norm going forward.

    @Mojtaba- Our torque tables are calculated based on the bolt yield strength. A320 L43 has the same yield as A193 B7, so you could use that table for your bolt.

Leave a Reply to Sean Johnston Cancel reply

Your email address will not be published. Required fields are marked *