Square Lag Screws

Square lag screws are used in wood construction and are often ordered for aesthetic purposes and provide a rustic look. Hex lag screws are more readily available in the marketplace as a standard stock item.

Manufacturing

Portland Bolt manufactures square lag screws from 1/2″ diameter through 1-1/2″ diameter in most ASTM, AASHTO, and SAE specifications. Special tooling can be created to produce nonstandard head dimensions or bolt heads with your company’s name and/or logo.

Unless otherwise specified, nonstandard lag screws manufactured by Portland Bolt will possess a semi-cone point rather than a gimlet or cone point. A full point is unnecessary since a pilot hole nearly as large as the root diameter of the lag screw will need to be drilled prior to installation. Additionally, a gimlet point is designed for small diameter screws so they can be installed without a pilot hole. Lag screws in diameters listed in the above table do not require a gimlet point since too much torque would be required to install the large screws without drilling a pilot hole first. Without a pilot hole, the heads of the screws will often break before the lag is properly installed.

• Cutting
• Heading
• Threading
• Hot-Dip Galvanizing

Standard Thread Length

The minimum thread length for square lag screws shall be equal to half the nominal screw length plus 1/2″ or 6″, whichever is less. One should consider longer than standard thread lengths for lag screws which are extremely long.

Square Lag Dimensions

Click table to show drawing