Category Archives: Washers

Stacking Washers with A325 Bolts

Is stacking of F436 washers acceptable with an A325 bolted connection?

Yes, in some cases the stacking of F436 washers seems to be allowed, but not in all cases. The Research Council on Structural Connections (RCSC) in Specification for Structural Joints Using High-Strength Bolts, December 31, 2009, page 16.2-12 says, “If necessary, the next increment of bolt length can be specified with ASTM F436 washers in... Read more

Welding Beveled Washers

Can I weld to your malleable beveled washers?

Along with shear plates and round malleable washers, malleable beveled washers are made with ASTM A47 cast malleable iron. See the following excerpts from ASTM A47. 11.3 Castings that have been repaired by the welding shall be reannealed so that the microstructure will comply with Section 8. (Section 8 of ASTM A47 lays out specific... Read more

Washers for Structural Bolts

Are washers required to be used with an A325 or A490 structural bolt?

It is known that the required grade of washer to be used with an A325 or A490 structural bolt is an ASTM F436 hardened washer, however whether or not a washer is required to be used in a given application is often brought into question. The purpose of using a flat washer with a bolt... Read more

Custom F436 Washers

My plans are calling for a 1" thick, 5" outside diameter ASTM F436 plate washer. My local supplier is telling me that F436 washers only come in standard sizes that are much smaller. Are these larger F436 plate washers available?

Yes. Custom F436 washers can be manufactured to larger sizes per your job’s requirements. Portland Bolt has been involved in many projects where custom F436 washers were specifically called for on a job.  However, ASTM F436 does not technically allow for custom sizes and only allows for very specific types and styles that conform to... Read more